Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Lake Worth Beach Homeowners
A broken spring usually announces itself: a sharp bang from the garage, and then a door that won’t lift. If that’s your morning, we handle garage door spring repair in Lake Worth Beach, often the same day you call. Our technicians have up to 15 years of experience, and they’re trained on the springs and hardware behind LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor systems. We diagnose the failure, quote the repair in writing, and agree the price with you before anything comes apart. Springs are the highest-tension part of the whole door, so this isn’t a job to guess at. Call (833) 756-5752 and we’ll get a trained technician out to look at it.
What Our Garage Door Spring Repair Service Includes
Every spring is different in how it fails, and the right fix depends on the setup above your door. We cover the full range, from a single snapped torsion spring to adjusting an extension setup that has stretched out of balance. Here’s what each part of the job involves.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a metal shaft above the door, and it carries most of the door’s weight through a system of cables and drums. You need replacement when the coil has snapped, when the door feels far heavier than it should, or when the opener starts straining to lift it. We measure the wire size, inside diameter and length of the existing spring so the replacement matches the door’s actual weight, then reset the cables and balance the door before we leave.

Extension Spring Replacement
Extension springs run along the horizontal tracks on either side of the door and stretch as the door closes. They’re common on older doors, and they’re the type that needs a safety cable threaded through the middle. We replace them in matched pairs, since a spring that has stretched for years alongside a new one will pull the door unevenly, and we fit or renew safety cables on every extension job. If one has already broken, don’t run the opener; the door is running on half its support.

Broken Spring Repair
When a spring breaks, the door typically becomes too heavy to lift by hand and the opener either strains, clicks, or gives up entirely. We confirm the break, check that the cables and drums weren’t damaged when it let go, and replace only what the door actually needs. The fix is usually straightforward once the door is safe to work on, and the goal is to hand it back working properly rather than patched together.

Spring Adjustment
An adjustment is for a door that still opens but feels wrong: heavy at the bottom, slow to rise, or jerky on the way down. Springs lose tension over time, and the balance can drift until the opener is doing work the spring should be doing. We measure the door’s balance, adjust the tension to spec, and check the travel limits so the door stops where it should. Left alone, a poorly balanced door wears out the opener and the rollers faster than it should.
Safety Cable Installation
Safety cables are the steel cables threaded through extension springs to contain them if they break. Many older Lake Worth Beach garages either never had them or have cables that are rusted or loose at the anchor point. We install or replace them as part of any extension spring job, and we check them on inspections too. It’s a small part of the system that matters a great deal when a spring lets go.
Spring Inspection
An inspection is a full look at the spring system, the cables, the drums, the bearings and the door’s balance, done before anything else is quoted. We check for gaps in the coil, worn cable strands, and a door that doesn’t hold position when you let go of it halfway up. If you’ve heard a noise but can’t see a break, this is the place to start. You get a clear picture of what’s worn out and what’s still got life in it.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on your brand, not just whatever brand happens to turn up. LiftMaster and Chamberlain systems are the most common openers we see paired with torsion setups, and we know how those units react when a spring fails, including the travel limits and force settings that need resetting once the spring is replaced. Raynor doors often use specific spring and drum combinations, so we match the replacement to the existing hardware rather than fitting a generic spring that leaves the door unbalanced.
Craftsman openers are common on older Lake Worth Beach doors, and the drive system and force settings on those units need checking after any spring work. We service all of these brands and the doors they’re attached to, whether you have a LiftMaster, a Chamberlain, a Raynor, a Craftsman or any other make, we can help. That brand familiarity is part of why the diagnosis is usually right the first time.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. A torsion spring breaking sounds like a gunshot, and it usually happens while the door is at rest. If you heard it and the door now won’t lift, stop using the opener and call us.
- The door feels impossibly heavy. Try lifting the door by hand with the opener disengaged. A properly balanced door lifts with one hand; if it takes real effort, the spring has lost tension or broken.
- The door opens a few inches and stops. An opener that lifts the door slightly then reverses is often fighting a spring that isn’t helping anymore. Don’t keep pressing the button; the opener’s gears and the door’s cables take the strain.
- A visible gap in the spring coil. Look at the torsion spring above the door or the extension springs along the tracks. A clear gap in the coil means it has snapped, and the door shouldn’t be operated until it’s replaced.
- The door hangs crooked or jerks on the way up. Uneven travel often points to one spring doing less work than the other, or a cable that’s slipped. It’s worth an inspection before it becomes a bigger repair.
Our Garage Door Spring Repair Process – Step by Step
- 1
Phone diagnosis and scheduling. When you call (833) 756-5752, we ask what the door is doing, whether it’s stuck open or closed, and what type of spring you have if you can see it. That lets us arrive with the right parts and give you a realistic idea of timing before we set foot in the garage.
- 2
On-site safety check and inspection. Before any work begins, we secure the door, check the cables and drums for damage caused when the spring let go, and confirm the balance and travel. We don’t wind or unwind a spring until we know the full system is sound, because a damaged cable under tension is a genuine hazard.
- 3
Written quote before work starts. We explain what failed, what needs replacing, and hand you a written price covering parts and labor. A matched pair is usually replaced together, so a pair costs about twice the single-spring range. Nothing gets started until you agree to the number.
- 4
Spring replacement and system reset. We fit the replacement spring or springs to the door’s actual weight, re-tension the cables, and reset the opener’s travel limits and force settings so it isn’t overworking. The door gets cycled and re-checked for balance before we call it done.
- 5
Final test and walkthrough. We run the door through several full cycles, check the safety reverse, and show you what we replaced and why. If we spotted anything else that’s wearing out, you’ll hear about it honestly, not as an upsell.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Lake Worth Beach?
Spring repair in Lake Worth Beach typically runs $180 – $340 for one spring, depending on the spring type, the door’s weight, and whether the cables or drums need attention too. A matched pair is usually replaced together, so a pair comes in around twice that range. Extension spring jobs often land near the lower end, while a torsion replacement on a heavier double door sits nearer the top. If the failure also damaged a cable, cable repair runs $130 – $250, and we’ll quote that separately rather than folding it into a vague total.
What affects the price: the number of springs, the door’s size and weight, whether the opener needs its limits reset, and whether the safety cables need replacing. The written estimate you agree to is the price you pay, and the final figure is set by that estimate, so there’s no surprise on the invoice. Our quotes include the spring, the labor, the balance check and the opener reset. To avoid overpaying, get the quote in writing before work starts and ask whether the price covers a pair or a single spring. For comparison, a full garage door repair covering panels, tracks or rollers can run $150 – $600 depending on what’s involved.
Garage Door Spring Repair Near Lake Worth Beach – Our Service Area
We cover spring repair across Lake Worth Beach and the surrounding communities, including Lake Clarke Shores, South Palm Beach, Lantana, Palm Springs, Atlantis, Greenacres, Hypoluxo, Kenwood Estates, Seminole Manor, San Castle and Pine Air. Response times depend on where you are and how busy the day is, but most spring calls in the core Lake Worth Beach area get same-day attention. If you’re just over the bridge in Palm Beach or down the road in Boynton, call and we’ll confirm timing. You can also read more about garage door spring repair in the neighboring communities.
Serving Lake Worth Beach, FL – Our Local Coverage Area
We serve Lake Worth Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Lake Worth Beach
Garage door spring repair is the replacement, adjustment or re-tensioning of the springs that counterbalance your door’s weight so the opener doesn’t have to lift the whole thing alone. Torsion springs sit on a shaft above the door, extension springs run along the side tracks, and both store a lot of energy. Repair means restoring that balance safely, then resetting the opener to match. If you’re not sure which type you have, we can tell you on the phone or at the inspection. Call (833) 756-5752 to book a look.
Most single-spring repairs are done in about an hour to ninety minutes on site, and a matched pair takes a bit longer because the door has to be re-balanced afterward. The bigger variable is getting the right spring, which is why we ask about your door’s type and size when you call. If we arrive with the right part, the job rarely runs past a couple of hours. Call (833) 756-5752 and we’ll give you a realistic window.
Typical spring repair in Lake Worth Beach runs $180 – $340 for one spring, and a pair is usually about double that since they’re replaced together. The price depends on spring type, door weight, and whether cables or drums need work at the same time. The written estimate sets the final price, and we agree it with you before any work starts. Call (833) 756-5752 for an exact quote, and estimates are free.
Yes. We service LiftMaster and Chamberlain systems along with Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. Our technicians know how those openers behave when a spring fails, including the travel and force settings that need resetting after the repair. If your door has a brand we haven’t named, we can still take a look. Call (833) 756-5752 and tell us what’s on the door.
In most cases, yes. Spring failures are one of the calls we prioritize because the door is usually stuck and the opener shouldn’t be used until it’s fixed. Emergency garage door service is a core part of what we do, not an add-on, so a broken spring gets a fast response whenever we can fit it. If your door is stuck open overnight, we’ll tell you how to secure it safely while you wait. Call (833) 756-5752 and we’ll give you the soonest slot.
We stand behind our spring work, and the terms are explained in writing before we start so you know what’s covered. Ask about the warranty on your specific spring when you get the quote, since the coverage depends on the part and the job. If something fails after we’ve been out, call us back and we’ll sort it. Call (833) 756-5752 with any warranty questions before you book.
Clear the area under and around the door, and if you can, leave the garage accessible so we can reach the spring assembly without moving a car. Don’t try to lift the door or run the opener once a spring has broken, because the weight is no longer supported and the cables can let go. If the door is stuck open, leave it and tell us when you call so we can advise you safely. Then just call (833) 756-5752 and we’ll take it from there.
Schedule Your Garage Door Spring Repair Service in Lake Worth Beach Today
Don’t leave a broken spring to strain your opener or leave the door stuck. Call (833) 756-5752 and we’ll get a trained technician out to diagnose it, quote it in writing, and fix it properly. Our team covers torsion and extension springs across Lake Worth Beach and the surrounding neighborhoods, and the estimate is free with no obligation. If you’d rather compare options first, look at our garage door spring repair in Lake Clarke Shores or garage door spring repair in South Palm Beach pages for the same straightforward pricing.
Written by the team at Garage Door Repair Lake Worth Beach.